Plate shears are used to cut all kinds of sheet metal materials with the thickness of the machine tool's rated value, and it is necessary to cut a whole piece of new materials that have not been welded and spliced. Today Pacific Machine Tool will talk about more details about the operating procedures of hydraulic plate shears:

1. Use of hydraulic plate shears

(1) Try to cut the plates of different thicknesses from thin to thick, and understand the functions of the blade of the hydraulic plate shears.

(2) It is necessary to adjust the clearance of different blades when the plate thickness is different.

(3) If there is any noise in the blade of hydraulic brake plate shearer during operation, stop the machine to check.

(4) For equipment with hydraulic equipment, it is forbidden to adjust other hydraulic valves without permission except for cutting.

(5) Open the pressure gauge switch during the cutting process of the blade of the hydraulic plate shear, and investigate the pressure value of the oil circuit.

(6) During operation, the temperature of the oil tank is less than 60 ℃. If it exceeds 60 ℃, shut down the machine for rest.

2. Operating procedures of hydraulic swing plate shears

(1) It is necessary for the operator to understand the structure and function of the machine;

(2) Check that the oil storage tank has enough oil.

(3) It is forbidden to shear the laminated sheet, trim the edge of the rough edge sheet, and cut the narrow sheet and short sheet that are not tightly pressed.

(4) The clearance between knife plates shall be adjusted according to the thickness of the plate.

(5) Regularly check the sharpness of the knife edge. If it is found that the knife edge is blunt, it should be honed or exchanged in time. For the sharpening of the blade, only the thickness of the knife needs to be honed;

(6) When shearing, the pressing equipment shall firmly press the sheet, and it is forbidden to shear when the pressing is not tight.

(7) The mesh oil filter installed on the oil suction port of the oil pump should always be checked and cleaned to keep the oil filter with the proper oil flow. If the oil filter is blocked, the oil flow will be reduced, which will make the oil pump empty and affect the service life of the oil pump;

(8) Finally, the upper cutter plate shall be placed at the lowest position.